SERVICE AND REPAIR
If you have problems with your WAHL product, send it
prepaid with a note explaining the problem to:
Wahl Clipper Corporation
Attn: Repair Department
3001 Locust Street
Sterling, IL 61081
Telephone (815) 625-6525
For products purchased outside the United States,
contact your distributor.
MASSAGER
INSTRUCTIONS
OPERATING INSTRUCTIONS
1. With both of the massager switches in the OFF position,
plug the power cord into an AC outlet. (Make sure the voltage
of power supply is the same as that indicated on massager.)
2. Place the desired massage attachment on the stem of the
massager. The attachments easily press on and pull off. If
heat is desired, the heat attachment must be used. (See
special instructions below for using the Deep Heat Attach-
ment.)
3. Slide the bottom switch to the desired massaging speed
I - LOW or II -HIGH.
■ I - LOW — for soothing massage.
■ II - HIGH — for vigorous, deep-penetrating action.
4. Slide the top switch to the desired heat setting
I - LOW or II - HIGH. Use heat only with the Deep Heat
Attachment. Heat may be applied alone or with the massaging
feature.
5. Apply the massager to the targeted area, using continual
movement. A circular motion is often most effective. (See
MASSAGE TECHNIQUES.)
DEEP HEAT ATTACHMENT
To insert Deep Heat Attachment, simply align the special track
bar with the grooved section in the massager stem (see
diagram), then press firmly onto stem. To detach, use thumb
and two fingers and pull away from stem.
When Deep Heat Attachment is
correctly aligned and pushed on
the stem, the electrical heat
element is automatically
connected. If using the mas-
sager for the first time, begin
with the lowest heat setting.
Test the surface for a comfort-
able temperature. The mas-
sager will heat to the desired level within four minutes.
NOTE: When using heat, always check temperature before
placing massager against skin. Every person reacts differently
to certain temperatures. We suggest the following before use
— check temperature by lightly touching with fingertips the
silver heat plate on the massager. If uncomfortable to your
touch, reduce temperature by (1) rubbing massaging surface
on soft cloth, (2) moving the HEAT button to a lower setting, or
(3) turning off unit for a short period before applying to your
skin. Keep the massager moving constantly any time heat is
on. Never use heat on swollen or inflamed areas, or on skin
eruptions.
NEVER use the heat applicator if the plastic housing is cracked
or broken, or if the metal plate is loose, bent or lifted.
CAUTION: The two holes in the stem of the massager are like
an electrical plug — electrical power is transmitted through
them. NEVER allow water near the stem, and never insert
anything into the holes.
MASSAGE TECHNIQUES
SHOULDERS AND NECK —
Massage each shoulder toward back of neck to point just
behind and below ear. Then back to shoulder. Repeat several
times.
ARMS — Start with a gentle massage of the palms and
fingers. Next, using a circular motion, move upward to
forearms. Then up tobiceps and shoulders.
LEGS — If desired, massage bottoms of feet. Then, using a
circular motion, massage each leg from calf on up and over
thigh.
CHEST — Massage from center of chest outward, and up
toward each shoulder.
BACK — Massage from top of spine to bottom, and from
center outward.
ABDOMEN —Relax abdominal muscles by massaging from
center outward, using a gentle, circular motion.
JOINTS —Relieve tired, aching knees and elbows with
smooth, circular strokes.
FACE — Gently massage from the nose outward, taking care
to avoid contact with the eye.
SCALP — Start at the back of the neck and massage up to the
top of the head. Using this up and down motion, massage
across the scalp.
CLEANING/STORAGE
Always unplug massager before cleaning.
To clean, simply wipe unit with a dry, soft cloth. Do not
immerse in water or use any harsh cleaners or solvents. When
storing unit, make sure cord is not twisted or kinked.
Line Voltage
Amplitude &
Frequency Setting
220/50
240/50
100/50
120/60
220/60
Vibration for Single-
speed Models
(vibrations/min.)
100 Hz
(6000)
120Hz
(7200)
2-Speed Models
LOW (1) HIGH (2)
Setting Setting
100 Hz 50Hz
(6000) (3000)
120 Hz 60 Hz
(7200) (3600)
MASSAGER VIBRATION FREQUENCY
Deep Heat
Attachment
Massager
Stem
ATTACHMENTS
Facial
1101-1001 (White)
1101-1101 (Black)
Heat
1105-1101 (New)
General Body
1102-1001 (White)
1102-1101 (Black)
Knuckle
1115-1001 (White)
1115-1101 (Black)
Deep Muscle
1104-1001 (White)
1104-1101 (Black)
Muscle Kneading
1116-1001 (White)
1116-1101 (Black)
Spot
1107-1001 (White)
1101-1101 (Black)
Scalp
1103-1001 (White)
1103-1101 (Black)
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals